BaerFix Thread Repair Kit UNC 3/8 x 16 like timesert

BaerFix Thread Repair Kit UNC 3/8 x 16 like timesertBaerFix Thread Repair Kit UNC 3 8 x 16 Applicable for materials like: aluminum, light alloys, nonferrous metals, brass, bronze, cast iron, synthetic materials, laminated plastics, hardwoods, plastics ect. For very hard and strong materials, it's recommended to tap the thread before the installation of the BaerFix insert. (You can find screw lockings at accessories) inside thread: UNC 3 8 x 16 Length: 18 mm External Thread: M 14 x 1,5 kit content: 1 x

Strong wire handle

BAER Round Cutting Die MF 10 x 1

Then screw the thread insert into the receiving thread under slight pressure until it is 1/4 - 1/2 turn below the surface

BaerCoil® thread inserts ensure optimum power transmission from the bolt to the nut thread

283 '' P (depth) The thread insert must sit 1/4 - 1/2 turns below the surface B (thread depth with chamfer) 0

electrical

two-piece hand taps- sets are used for fine threads with a smaller pitch than at coarse thread

This is where BaerFix® thread insert comes to the rescue

It has the ability to penetrate the minute grain boundaries on all metals

Every material shows individual chip behaviour

IMPACT STRENGTH - unique rubber particles increase impact-resistance and strength to handle everyday use after your repair or creation is set

The inserts are precise and wear resistant - your screw will stay firmly in place without the thread insert slipping out